Services Available | |
---|---|
Repair | Yes |
Calibration | Yes |
Free Support | Yes |
The SDMX50LP is one of three 50 ohm coaxial, 8:1 multiplexers that can be used in a TDR100-based system. This multiplexer was designed to be mounted inside of a user-supplied enclosure. It consists of a surge-protected multiplexer circuit board attached to one end of a powder-coated backplate. The multiplexer circuit board extends about 5” (13 cm) from the backplate, resulting in an L-shaped unit. Holes in the backplate provide strain relief for the coaxial cables.
Strain Relief Bracket Dimensions | 26.7 x 27.9 x 1.3 cm (10.5 x 11 x 0.5 in.) |
Circuit Board Dimensions | 24.9 x 12.2 x 4.6 cm (9.8 x 4.8 x 1.8 in.) |
Power Requirements |
|
Input Power | 12 Vdc |
Quiescent Current Drain | < 1 mA |
Current Drain during Switching | ~ 90 mA (All multiplexers of the same level switch simultaneously for less than 1 s.) |
Number of FAQs related toSDMX50LP:6
Expand AllCollapse All
These three multiplexers all use the same relay board, but the housing differs. The multiplexers are described side-by-side on page 2 of thisbrochure.
The most popular model is the SDMX50SP, followed by the SDMX50.
PC-TDRis a free download in the Downloads section ofthe PC-TDR web page..
In applications where TDR probes are used to measure soil water content, the maximum distance from the TDR probe back to the TDR100/TDR200 (even through one or more multiplexers) cannot exceed 15 m (50 ft) when using RG58 coaxial cable; the CS605-L, CS630-L, and CS640-L TDR probes have an RG58 cable. When using low-loss coaxial cable, the distance cannot exceed ≈25 m (80 ft); the CS610-L, CS635-L, and CS645-L TDR probes have a low-loss coaxial cable.
In slope stability and rock mass deformation applications, the maximum coaxial cable length should not exceed ≈1 mile (5,280 ft). The maximum combined length of all SDM cables in the system should not exceed ≈76 m (250 ft).
We've updated our privacy policy.Learn More