可用服务 | |
---|---|
维修 | No |
Calibration | No |
免费支持 | No |
RF400是一个100 MW扩频无线电/调制解调器,用于点对点和点对多点数据记录器通信。它可以用作连接到数据记录器的现场无线电/调制解调器或作为连接到计算机的基站无线电/调制解调器。RF400有一个910至918 MHz的工作频率范围,用于美国/加拿大。
注意:在图像中,RF400显示为14204室内天线。
运行频率 | 910到918 MHz |
类型 | 跳频扩频(FHSS)收发器 |
I / O数据速率 | 9600 BPS. |
渠道容量 | 6.5,000 Network Identifiers share 25 hop channels. |
Frequency Hopping Patterns | 六种不同的可选模式 |
Frequency Control | 直接FM. |
接收器敏感性 | -110 dbm 10-4位错误率Campbell Scientific协议将在发生误码时发出重试。 |
接口拒绝 | 70 dB (at pager and cellular phone frequencies) |
变送器电源输出 | 100 mW (nominal) |
Antenna Connector | 反向极性SMA |
FCC ID. | 我们的9xtream |
工作温度范围 | -25° to +50°C |
力量 | 9 to 16 Vdc |
LEDs | 电源,TX,RX,诊断 |
CS I/O Connector | 9-pin “D” male for all needed communications lines. Newer loggers provide power to the radio on this connector. Older loggers may require optional power cable pn 14291. |
RS-232 Connector | TX,RX,CTS,地面RS-232级别9针“D”女性 |
电源连接器 | Barrel connector, center positive 12 V for use in base station configuration or with older data loggers. Newer loggers provide power to the radio on the CS I/O connector. |
方面 |
|
重量 | 227克(8盎司) |
平均电流消耗 |
|
支持 | <1 mA(假设使用省电选项) |
Receiving | 24马 |
传输 | <75 ma. |
笔记:The following shows notable compatibility information. It is not a comprehensive list of all compatible or incompatible products.
产品 | 兼容的 | 笔记 |
---|---|---|
21X(退休) | ||
CR10(退休) | ||
CR1000(退休) | ||
CR1000X. | ||
CR10X.(退休) | ||
CR200x.(退休) | ||
CR206x(退休) | ||
CR211x.(退休) | ||
CR216x.(退休) | ||
CR23x.(退休) | ||
CR295x.(退休) | ||
CR300. | ||
CR3000(退休) | ||
CR500(退休) | ||
CR5000(退休) | ||
CR510(退休) | ||
CR6 | ||
CR800. | ||
CR850 | ||
CR9000(退休) | Although the CR9000X and CR9000 are compatible, the RF400 radio does not support their fastest communication rates, and is therefore not practical for most of their applications. | |
CR9000X(退休) | Although the CR9000X and CR9000 are compatible, the RF400 radio does not support their fastest communication rates, and is therefore not practical for most of their applications. |
产品 | 兼容的 | 笔记 |
---|---|---|
ENC10 / 12. | ||
ENC10 / 12R. | ||
ENC12 / 14. | ||
ENC14/16 | ||
enc16 / 18 |
The RF400 can transmit data to another RF400 radio or a CR205 datalogger. The RF400 may also be used in a network with RF401 radios and/or CR206(X) dataloggers if all of the RF401 radios and CR206(X) dataloggers are set to the transparent mode.
Campbell Scientific不建议使用包含FGR-115或RF450无线电的网络中的RF400。
需要干燥,不冷凝的环境。14162安装套件包括用于将RF400固定到机箱背板的硬件(参见订购信息)。
Current RF400, RF410, RF415 firmware. Requires the Device Configuration Utility.
用于下载操作系统并设置Campbell Scientific硬件的软件实用程序。如果以前由另一个Campbell Scientific软件包安装,还将更新Pakbus图表和网络规划员。
支持ed Operating Systems:
Windows 11,10,8.1,8和7(32和64位)
与之相关的常见问题解答数量RF400.:6.
Expand AllCollapse All
The functions of the RF401-series and RF400-series are essentially the same when using the透明具有混合阵列数据记录器操作系统的协议。最大的变化是在RF401中添加两个新的协议选项:PB意识到andPB Node。These new protocol options make the radio easier to use in a PakBus network.
为了实现原始RF401的相同特性和性能,请将主要的RF400订购到RF401升级服务(PN 18207.)。
对于RF401A与RF400通信,必须将RF401A配置为使用透明communications option.
是的。RF401A协议需要设置为透明,它将与RF400设备通信。然而,如果存在设置为28,44,52,56或60的地址的RF400设备,则必须在将RF401A无线电添加到网络时改变它们。
不可以。在这种情况下,基础RF401A只能通过RF400设备通信透明通信协议,或通过Pakbus协议使用CR206x数据监控器。
我们更新了我们的隐私政策。了解更多