Services Available | |
---|---|
Repair | No |
Calibration | No |
Free Support | No |
The MCR1 is only compatible with our mixed-array data loggers and the DSP4 Heads Up Display. (See the Compatibility information.) In a single package, it includes both the CSM1 and a SC532(A). The MCR1 connects to an IBM-compatible computer via a 7026 cable (supplied). AC power and SMS software are required.
Please note that availability varies by country; please contact a Campbell Scientific office or representative to discuss your data storage requirements.
Read MoreThe MCR1 is only compatible with our mixed-array data loggers and the DSP4 Heads Up Display. (See the Compatibility information.) In a single package, it includes both the CSM1 and a SC532(A). The MCR1 connects to an IBM-compatible computer via a 7026 cable (supplied). AC power and SMS software are required.
Please note that availability varies by country; please contact a Campbell Scientific office or representative to discuss your data storage requirements.
Memory Configuration | Fill-and-stop; data segregated into files by filemarks |
Baud Rate | Data transfer is typically 9600 or 19,200 baud. Contact Campbell Scientific for information on using the module with Burst Mode. |
Supply Voltage | 110 Vac to 7.5 Vdc adapter (factory installed) or 6 to 17 Vdc (with modification by user) |
Interface Type | 25-pin, D-type sub-miniature socket, RS-232C DCE interface |
RS-232 Output Levels | 5 V (minimum with 3000 Ω load) |
Current Drain @ 25°C |
|
Quiescent | RTS low = 16 mA (maximum) |
Active | memory test (worst case) = 30 mA (typical) |
RS-232 Input Levels |
|
Low Threshold | 0.8 V (maximum) |
High Threshold | 2.0 V (minimum) |
Maximum Input Limit | 30 V |
Minimum Input Resistance | 3500 Ω |
Note:The following shows notable compatibility information. It is not a comprehensive list of all compatible or incompatible products.
Product | Compatible | Note |
---|---|---|
21X(retired) | ||
CR10(retired) | ||
CR1000(retired) | ||
CR10X(retired) | ||
CR200X(retired) | ||
CR206X(retired) | ||
CR211X(retired) | ||
CR216X(retired) | ||
CR23X(retired) | ||
CR295X(retired) | ||
CR3000(retired) | ||
CR500(retired) | ||
CR5000(retired) | ||
CR510(retired) | ||
CR800 | ||
CR850 | ||
CR9000(retired) | ||
CR9000X(retired) |
Product | Compatible | Note |
---|---|---|
DSP4(retired) |
The MCR1 is only compatible with mixed-array data loggers (see below). Data loggers that store data in a table-based format are not compatible. Older data loggers may require a PROM upgrade.
The MCR1 uses one JEIDA 4, PCMCIA card; proper MCR1 operation is guaranteed only with cards tested by Campbell Scientific.
We've updated our privacy policy.Learn More