Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, pleasesubmit your question from the Ask a Question page.


Log inorregisterto post/reply in the forum.

CR1000X vs. CR1000 period average measurement

BFLyles Oct 29, 2019 01:54 AM

I recently upgraded a station from a CR1000 to a CR1000X. I am using period average to measure a Geonor T-200b precipitation gauge. I got stable readings for years with the CR1000, but I can't figure out how to get stable readings with the CR1000X.

Code stip from the CR1000: PeriodAvg (Geonor_Hz,1,mV2_5,16,0,1,1000,1000,1.0,0)

Code snip from the CR1000X: PeriodAvg (Geonor_Hz,1,2,16,0,1,1000,1000,1.0,0)

I am guessing it has to do with the gain setting in the CR1000X.

Has anybody put an osciloscope on the Geonor to see what the signal looks like?

Has anybody connected a Geonor gauge to a CR1000X?

ashcash 2022年2月8日07:00PM

By any change did you figure this out? I'm experiencing the same issue adapting an old code to the CR1000X

Log inorregisterto post/reply in the forum.
Baidu