可用的服务 |
---|
The CS300, manufactured by Apogee Instruments, measures total sun and sky solar radiation for solar, agricultural, meteorological, and hydrological applications. Its spectral range of 360 to 1120 nanometers encompasses most of the short-wave radiation that reaches the Earth's surface. This pyranometer connects directly to our data loggers. Its output can be measured by our data loggers.
阅读更多产品模型上的“ -l”表示电缆长度在订单时指定。
CS300使用安装在余弦校正头部的硅光伏检测器提供太阳辐射测量。它的圆顶形头可防止水积聚在传感器头上。为了消除内部凝结,传感器头是固体盆栽,并用坚固的santoprene套管遮盖了电缆。CS300通过Kipp&Zonen CM21热门射击计校准,以准确测量太阳加天空辐射。
Spectral Range | 360 to 1120 nm (wavelengths where response is 10% of maximum) |
Measurement Range | 0到2000 w/m2(全阳光约1000 W/m2) |
绝对准确性 | 每日总辐射的±5% |
Sensitivity | 5 mV/Wm-2 |
校准因子 | 5 w/m2/mV |
余弦校正误差 | 在75°天顶角处±5%;在45°天顶角下±2% |
温度响应 | 0.04 ± 0.04% per °C |
Response Time | < 1 ms |
长期稳定性 | <每年2% |
工作温度范围 | -40° to +70°C |
Relative Humidity Range | 0至100% |
Output Sensitivity | 0.2 mV/W/m2 |
Diameter | 2。4 cm (0.9 in.) |
Height | 2.5厘米(1.0英寸) |
重量 | 65 g (2.3 oz) with 2-m (6.6-ft) lead wire |
笔记:The following shows notable compatibility information. It is not a comprehensive list of all compatible or incompatible products.
产品 | 兼容的 | 笔记 |
---|---|---|
21X(退休) | ||
CR10(退休) | ||
CR1000(退休) | ||
CR1000X | ||
CR10X(退休) | ||
CR200X(退休) | ||
CR206X(退休) | ||
CR211X(退休) | ||
CR216X(退休) | ||
CR23X(退休) | ||
CR295X(退休) | ||
CR300 | ||
CR3000 | ||
CR310 | ||
CR500(退休) | ||
CR5000(退休) | ||
CR510(退休) | ||
CR6 | ||
CR800 | ||
CR850 | ||
CR9000(退休) | ||
CR9000X(退休) |
Accurate measurements require the sensor to be leveled using a 18356 leveling fixture. This leveling fixture incorporates a bubble level and three adjusting screws. The 18356 mounts to a crossarm or a tripod or tower mast using the CM225 mounting stand. The CS300 should be mounted away from all obstructions and reflective surfaces that might adversely effect the measurement.
每个探针需要一个微分类似输入通道。
与CS300-L:9
Expand AllCollapse All
平稳基础提供了物理稳定性,并有助于确保传感器正确平整。不建议没有底座的传感器。传感器用随附的螺栓安装在底座上。但是,可以使用带有孔的用户供应板,而可以使用传感器的安装螺栓。
笔记:无论使用什么安装方法,都必须将传感器升级才能正确操作。
Campbell Scientific does not recommend splicing any cable into the existing cable. Splicing a cable could introduce water and electrical noise into the connection. The sensor can be ordered with longer cable lengths, and 50 m is right on the edge of the recommended length. With a cable this long, Campbell Scientific recommends measuring the sensor differentially using the following wiring conventions:
电线颜色 |
数据记录器频道 |
红色的 |
diff通道h |
黑色的 |
diff通道l |
透明(盾牌) |
AG or Ground Symbol |
JUMPER WIRE |
diff通道lto AG or Ground Symbol |
在数据记录程序程序中,需要使用差分电压指令代替单端电压指令。
Compare the sensor against a recently calibrated CS300-L on a clear, sunny day with the sun overhead. Ensure that the sensor being used as a reference is also level.
否。这不是使传感器成为量子传感器的范围。这是光电器与光电器一起使用的轻滤波器的类型,仅允许在PAR频率范围内特定的光波长击中光电器。
大多数坎贝尔科学传感器都可以作为–L提供,该传感器表示用户指定的电缆长度。如果将传感器列为–LX模型(其中“ X”是其他字符),则传感器的电缆具有用户指定的长度,但它用特定的连接器终止了独特系统:
如果传感器在主型号之后没有–L或其他-LX名称,则传感器具有设置的电缆长度。电缆长度在产品订购信息中的描述字段末尾列出。例如,034B-ET型号的描述说明“遇到了一个为ET站的一组,67英寸电缆”。具有固定电缆长度的产品,默认情况下,带辫子。
If a cable terminates with a special connector for a unique system, the end of the model number designates which system. For example, the 034B-ET model designates the sensor as a 034B for an ET107 system.
Not every sensor has different cable termination options. The options available for a particular sensor can be checked by looking in two places in the Ordering information area of the sensor product page:
If a sensor is offered in an –ET, –ETM, –LC, –LQ, or –QD version, that option’s availability is reflected in the sensor model number. For example, the 034B is offered as the 034B-ET, 034B-ETM, 034B-LC, 034B-LQ, and 034B-QD.
所有其他的电缆终端选项,如果艾娃ilable, are listed on the Ordering information area of the sensor product page under “Cable Termination Options.” For example, the 034B-L Wind Set is offered with the –CWS, –PT, and –PW options, as shown in the Ordering information area of the 034B-L product page.
笔记:由于通常将较新的产品添加到我们的库存中,因此我们将在单个传感器模型下列出多个电缆终止选项,而不是创建多个模型号。例如,HC2S3-L具有将其连接到CS110而不是提供HC2S3-LC模型的–C电缆终止选项。
许多坎贝尔科学传感器都有不同的电缆终止选项。这些选项包括以下内容:
笔记:电缆终止选项的可用性因传感器而异。例如,传感器可能没有,两个或几个选项可供选择。如果未列出特定传感器的所需选项,请联系Campbell Scientific寻求帮助。
要将与无线传感器接口兼容的传感器合并到无线网络中,需要CWS900系列无线传感器接口,以及A205 CWS-TO-PC接口进行配置。
我们已经更新了我们的隐私政策。学到更多