byJanet Albers| Updated: 11/30/2016 | Comments: 0
If you use Campbell Scientific data logger support software to connect to your data logger, you may monitor your data from within the software. Have there been times when you’ve seen “Undefined” or “N/A” instead of your data values? What does that mean, and how do you fix it? In this brief article, we’ll look at what to do—whether you’re usingLoggerNet,PC400, orPC200Wsoftware.
In the LoggerNetConnectscreen, clickNum Display(Numeric Display) from the menu bar and selectDisplay 1,显示2, or显示3. If you see "Undefined" listed instead of your values, it means that those variables are not available for display.
Undefined values are often caused by a changed or different program running from the one that was running when the Numeric Display was set up.
To replace "Undefined" with your real-time values in the Numeric Display, follow these steps:
If you use the PC400 or PC200W Monitor Data tab, you may see "N/A" listed instead of your values. This means that those variables are not available for display. Frequently, this is caused by a changed or different program running from the one that was running when the Monitor Data tab was set up.
To replace "N/A" with your real-time values in the Monitor Data tab, follow these steps:
Whether you use LoggerNet, PC400, or PC200W with your Campbell Scientific data logger, I hope this article helps you replace any “Undefined” or “N/A” values with your real-time values.
Recommended for You:To learn more about the Table Monitor, read the"Tips and Tricks: More Than a Monitor" newsletter articleand watch the"LoggerNet Software | Changing Variables" video. |
If you have any questions, post them below.
Comments
Pleaselog in or registerto comment.